Well Pump Repair in Apopka and Surrounding Areas
Across Central Florida, the Floridan aquifer sits roughly 100 to 200 feet below the surface, so the pump that feeds most homes around Apopka hangs deep inside a cased well, not on a pad in the yard. That one pump carries the whole household: showers, laundry, the dishwasher, and often the sprinklers too. When it fails, there is no city line to fall back on, and the water stops at every tap at once. Pump Repair Services Apopka repairs and replaces well pumps for homes, farms, nurseries, and small commercial properties in Apopka and the surrounding communities.
Most of the wells we service run a submersible pump, a control box or two-wire motor, a pressure switch, and a bladder tank that keeps the pump from starting every time someone opens a faucet. Shallower wells use jet or centrifugal pumps mounted above ground. The motor is often not the first part to go. Ants packed into the pressure switch, a waterlogged tank that makes the pump short-cycle, a cracked drop pipe, or storm damage to the wiring are far more common, and each one costs less to fix than a new pump. That is why we diagnose the whole system before recommending a repair or a replacement.
Types of Well Pumps We Repair
Submersible well pumps
The most common pump on deep wells around Apopka. The motor and pump sit together at the bottom of the drop pipe, often 100 feet down or more, and push water up to the pressure tank. Because they stay submerged, they run cool and never lose prime, which is why a well-matched submersible can stay in service for well over a decade. When one fails, the cause is usually electrical: a burned motor winding, a failed start capacitor in the control box, or a splice that has let water in.
Shallow and deep well jet pumps
Jet pumps sit above ground, in a pump house or beside the wellhead, and use an impeller and a venturi nozzle to pull water up the suction line. Shallow-well models handle water within about 25 feet of the surface, while deep-well and convertible models add a second pipe to reach farther down. They are easy to reach, but they depend on a tight suction line and a working foot valve. Lost prime, a clogged nozzle, or a leaking shaft seal will leave the pump running with little water to show for it.
Centrifugal well pumps
Common on shallow irrigation wells and older properties where the water table sits close to the surface. A centrifugal pump moves a large volume of water at moderate pressure, which suits sprinkler zones and nursery watering, but it cannot lift water from very far down. The St. Johns River Water Management District notes that once the water level in a well drops 25 feet or more below land surface, a centrifugal pump is no longer adequate. Through a long dry stretch, that can mean adding drop pipe or switching to a jet pump.
Constant pressure and variable speed systems
Some newer homes run a submersible pump controlled by a variable frequency drive, which speeds the motor up or down to hold steady pressure instead of cycling on and off. These systems keep pressure even across several fixtures at once, but they add electronics that do not tolerate heat, power surges, or lightning well. We service and repair existing constant pressure and VFD systems, including drive faults, failed pressure sensors, and the pump and motor working underneath them.
OUR REVIEWS
Our goal is to provide the best service and customer experience.
Signs of Needed Well Pump Repair or Replacement
The clearest sign is no water at all, but most well pumps warn their owners first. Pressure that fades during a shower and recovers a few minutes later points to a pump that can no longer keep up, a clogged intake screen, or a falling water level. A pump that clicks on and off every few seconds is short-cycling, usually because the bladder tank has lost its air charge or the tank itself has failed. That rapid starting overheats the motor and burns the contacts in the pressure switch, so a tank problem left alone often turns into a pump problem.
Changes in the water matter too. Sand or grit in the aerators can mean a worn pump, a damaged well screen, or a pump set too close to the bottom of the well. Spitting faucets and milky water suggest air entering through a leak in the drop pipe. A breaker that trips after a summer storm, a motor that hums without starting, or a power bill that jumps with no change in water use all point to an electrical fault in the pump, the control box, or the wiring between them. Each of these gets more expensive the longer the pump keeps running on it.
Pump Repair Services Apopka offers reliable repair or replacement of well pumps in Apopka
When a well pump starts acting up, it is safer to leave the wellhead and control box closed. The system runs on 240-volt power and a pressurized tank, and a wrong guess about the cause can turn a simple switch replacement into a new pump. Call Pump Repair Services Apopka instead. Our licensed and insured technicians diagnose the whole system, explain what failed and why, and repair or replace the pump with equipment matched to the well. We service every type of well pump, from shallow jet units to deep submersibles, and we answer the phone 24/7, with decades of Central Florida well experience behind every call.